Osha Roof Fall Protection Requirements

Fall protection for activities not in the construction industry is addressed in specific standards for the general industry shipyard employment marine terminals and longshoring industry this section highlights osha standards federal register notices rules and proposed rules preambles to final rules background to final rules directives instruction to osha staff letters of.

Osha roof fall protection requirements.

Note to paragraph g. For general industry employers must ensure that workers are protected at heights of 4 feet or more 1910 28 b 1 i. Section 1910 28 establishes the requirements that employers must follow on the use of cages and wells as a means of fall protection. Unprotected sides and edges.

Fall protection systems and other equipment they will be using on the job. Implement safe work practices to reduce the possibility of falls. Each employee on a steep roof with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems with toeboards safety net systems or personal fall arrest systems. With regard to fall protection requirements applicable to the construction work itself 1926 501 b 10 low slope roofs requires conventional fall protection a combination of a monitoring system and warning line or on roofs of 50 feet or less in width a monitoring system alone i e without a warning line be used.

Each employee on a walking working surface horizontal and vertical surface with an unprotected side or edge which is 6 feet 1 8 m or more above a lower level shall be protected from falling by the use of guardrail systems safety net systems or personal fall arrest systems. Supervise workers to ensure fall. When work is performed at least 6 feet 1 6 m but less than 15 feet 4 6 m from the roof edge the employer must ensure each employee is protected from falling by using a guardrail system safety net system travel restraint system or personal fall arrest system. Each employee on a steep roof with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems with toeboards safety net systems or personal fall arrest systems.

Under the standard. In regards specifically to roof fall protection the 1910 standard specifies for low slope roofs that when work is performed less than 6 feet 1 6 m from the roof edge the employer must ensure each employee is protected from falling by a guardrail system safety net system travel restraint system or personal fall arrest system.